Cleaning. Protection.
We don't just clean. We protect.
Dry ice at -78°C lifts dirt without touching the paint. Then we apply anti-corrosion treatment so it stays clean.
We work on BMW, Mercedes, Audi, Porsche, Toyota, Land Rover and any other vehicle.
Cleaning + Protection
Two steps. No shortcuts.
Cryogenic cleaning
Dry ice pellets hit the surface at -78°C. Dirt, grease, and rust lift away. The ice evaporates. Nothing left to wipe.
- Does not scratch paint or chrome
- Safe on sensors, wiring, and electronics
- No water, no chemicals
Anti-corrosion treatment
Clean metal rusts faster if left exposed. We apply an anti-corrosion coating right after cleaning, while the surface is perfect.
- Underbody, engine, body panels
- Resists salt, mud, and moisture
- The difference shows at the next vehicle inspection
Why dry ice
No chemicals
Pure dry ice. It evaporates. Nothing drains into the sewer.
No scratching
Paint, chrome, and plastic stay intact. This is not sandblasting.
Anti-corrosion
We apply treatment right after cleaning, while the metal is exposed.
No drying time
The ice evaporates instantly. Start the engine and go.
Visible results
We take before-and-after photos. The difference is clear to the eye.
Any vehicle
BMW, Mercedes, Porsche, Land Cruiser, agricultural equipment. If it has an engine, we clean it.
What we clean
Choose your vehicle type and book
Cars
- Engine and engine bay cleaning
- Underbody and floor cleaning
- Exterior body cleaning
- Full anti-corrosion treatment
Motorcycles
- Motorcycle engine cleaning
- Frame and component cleaning
- Fairings and fuel tank cleaning
- Full anti-corrosion treatment
Any questions?
What is dry ice blasting?
Dry ice blasting uses dry ice pellets (-78 degrees C) propelled by compressed air. On impact, the dry ice sublimates instantly, lifting dirt without leaving residue or damaging the surface.
Is it safe for paintwork and sensitive components?
Yes. Unlike sandblasting or chemical cleaning, dry ice is non-abrasive and does not damage paint, chrome, plastic, or electronic components.
Why do you apply anti-corrosion treatment after cleaning?
Clean metal rusts faster if left unprotected. We apply anti-corrosion coating immediately after cleaning - it bonds better to a clean surface.
How long does the full process take?
It depends on the vehicle and how dirty it is. A standard clean takes 2-4 hours; the anti-corrosion treatment adds another 30-60 minutes. We give an accurate estimate when you book.
What types of vehicles do you work on?
BMW, Mercedes, Audi, Porsche, Toyota, Land Rover, motorcycles, trucks, and agricultural machinery. If it has an engine or a chassis, we can clean it.
Where do your customers come from?
Most are from Cluj and the surrounding area, but we also see customers from Sibiu, Targu Mures, Alba Iulia, and Bistrita. We are close to the A3/A10 motorway, so the drive is short from any direction.
How much does cleaning cost?
It depends on the vehicle and how dirty it is. The inspection costs 150 lei and is deducted from the service cost if you choose to proceed. Book online for a personalised assessment.
How do I book?
Fill in the online form in 3 steps: vehicle details, contact details, and signing the digital contract. You receive confirmation by email.